• Console box (item no. 7160-0412)
• Cup holder (item no. 7160-0846) 
• Vertical surface mount (item no. 14593) 
• Hardware bag (item no. 7120-0539) 

Note: Only the accessories listed above are included in the kit. Items such as control heads, radios, docking stations, motion attachments, computers, toggle switch plates, and locking pocket shown in photos are not included.  ​

• On top of transmission hump

• Bucket

• No - Attaches to transmission hump

• Heavy gauge steel, fully welded constructed for long-term durability.
• Black powdercoat finish for maximum corrosion resistance.
• Low profile, no-drill vehicle specific console box.
• Six (6) fasteners for mounting to transmission hump.
• A removable top and center plate for easy radio installation and wire routing.
• 12 Volt plug insert located on passenger side.
• Factory USB and audio jack must be relocated using item no. 16648 & 15082 or 16648 & 15083 if you want to use them.
• Four (4) 12 Volt knockouts located on passenger side.
• Computer can be mounted on top of the console box and be off-set towards the passenger on the “smiley face pattern” or mounted to the driver side with the 3-bolt hole pattern. 
• Horizontal, low profile section accommodates a mounting space of 11” (27.9 cm) long to house radio control heads, full-sized devices and accessories. The included cup holder uses 4.5" (11.43 cm) of that space.
• Vertical, angled section accommodates 7.5” (19.1 cm) of mounting space to house 1 to 2 full-sized radios.

Notes